LaChapell Audio 500CS
500CS CHANNEL STRIP
500 Series Channel Strip with EQ and Compressor
The 500CS Channel Strip from LaChapell Audio is a complete channel strip featuring a pristine OpAmp based solid state preamp, high and low pass filters, full 3-band EQ and VCA compressor in one unit.
Each “half” of the unit can function independently for maximum value and versatility. Track with the preamp, eq and compressor together, then switch to independent mode and use the eq/compressor side as an outboard processor.
INTERNAL GAIN 60 dB
Frequency Response 6 Hz – 45.5+ kHz
Max Output 28.12 dBu
Typical EIN -128
Input Impedance 3 KΩ Mic / 20 KΩ Hi-Z
Maximum Input Level 7 dBu
Noise Floor < 94.5 dB – 20 hZ to 20 kHz
Frequency Response 5 Hz – 36 kHz (+/- .28 dBu)
Cut/Boost Range +/- 12dB
Maximum Input Level 27.65 dBu
Bands 3 Band
High Pass Filter 6 dB per octave at 142 Hz
Low Pass Filter 6 dB per octave at 7 kHz
Knee Hard/Soft Selectable
Slow Setting 5 ms Attack, 65 ms Release
Fast Setting 3 ms Attack, 13 ms Release
COMPLETE 500 SERIES CHANNEL STRIP
The 500CS Channel Strip is a two bay 500 series module that works with all 500 series frames and power supplies. Except of course single bay frames.
MASTERING QUALITY EQ
A three band EQ with additional High and Low Pass Filters give flexibility to your tracking and mixing. The transparent mastering grade EQ was designed to minimize phase interactions.
FRONT PANEL HI-Z
The front panel Hi-Z input allows the 500CS to be used as an instrument preamplifier. When a 1/4″ jack is inserted into the Hi-Z input, the 500CS switches into instrument mode.
The two knob compressor on the 500CS gives you ratio and threshold controls for flexible but forgiving compression. Select between fast or slow attack and release, and hard and soft knee settings with dip switches on back panel.
TWO IN ONE SPLIT MODULE OPERATION
The 500CS Channel Strip works in series or independently. Press the Module Split button to use the 500CS as two separate modules. Each section can be bypassed also so that you can use just the EQ, or just the compressor.
An analog VU with function selector lets you know exactly whats going on. The selector switch allows you to monitor the preamp output, the gain reduction of the compressor or the total output of the unit.
Comes with Manufacturer's Warranty.